Anchor Express

BENNETT A1200S Actuator Assembly

CONVENIENCE:
When passengers move, speed changes, wind shifts, or water conditions change, the ATC system adjusts your trim tabs. . . automatically.

MAXIMUM EFFICIENCY:
The ATC diligently and consistently adjusts your boat to the optimum attitude you set in its memory. It obtains and processes information on your boat's attitude and decides how to make the necessary attitude correcting trim tab adjustments.

ENJOYMENT:
You'll have confidence and satisfaction knowing your boat's attitude is being monitored. The ATC not only does the work for. . . it does it better than you

INSTALLATION IS EASY
Mount the Attitude Sensor virtually anywhere in the boats (location is not critical as sensor will adapt to off-center installation). Run the sensor cable to the small computer modules located under the helm, then interface with the trim tab wire harness. Install the Helm Keypad and the installation is complete!

OPERATING INSTRUCTIONS
After you've installed the system, get your boat up on plane and trim to what you consider the best running attitude. Then press the two 'SET ZERO' buttons on the keypad. From then on, each time you turn it on, the ATC will automatically activate the trim tabs enabling your boat to achieve the attitude setting residing in its memory. The zero point can be reset by following the same procedure again. The ATC system is deactivated by touching the helm keypad 'OFF' or pressing the manual trim tab control.