Anchor Express

Our mid-sized marine bilge heater provides forced-air heat through a patented case design to keep your engine compartment safely above freezing. The Boatsafe boat heater does this while maintaining ignition protection. When the boat heater's sensor detects an ambient temperature of approximately 45 Fahrenheit (7.2C), it turns on and remains on until the engine compartment reaches approximately 55 Fahrenheit (12.7C).

Benefits of using Boatsafe Marine Engine Compartment Heaters

• Extend your boating season
  
• Delay Boat Winterization
  
• Economical to use
  
• Keeps engine(s) and wiring dry and corrosion free
  
• Improve battery performance
  
• Enhances the resale value of your boat
  
• Save money by eliminating the annual costs of winterizing & de-winterizing your boat engine(s) in some climates
  
• All Boatsafe bilge heaters meet U.S. Coast Guard Ignition Protection Standards
  
• Extensively tested for your safety and benefit
  
• Endorsed by thousands of boaters like yourself
  
• Full TwoYear Warranty plus a lifetime service guarantee on all Boatsafe boat bilge heaters

(For Engine Compartments of 150 cu. ft. or less) (Boats with single engine, up to 24', or most sailboats)


NOTE: This heater WILL NOT provide adequate

protection for a boat that is stored out of the water on a lift, or on a trailer.


UNIT DIMENSIONS:

• 51/2"H x 41/2"W x 141/2" L - 1" Mounting Bracket at each end of unit. Weight - Approximately 4 lbs.

UNIT ENCLOSURE:

• 16 Ga. aluminum. Designed for exceptional strength and long life. CAD Vents for proper air flow and maximum heat distribution. Fully Powder Coated for scratch and corrosion resistance.

HEATING ELEMENT:

• 250W, Cast Alloy, completely sealed, specially designed and engineered for this application. Cast Alloy provides excellent corrosion resistance. Vibration resistant. Will not spark. UL recognized.

THERMOSTAT CONTROL:

• Hermetically sealed. Factory calibrated and pre-set to activate heater unit when ambient air temperature falls below 45 F (approximately), and continue operation until ambient reaches 55 F (approximately). FM approved.

FAN:

• Heavy Duty, computer style induction fan. Rated at 21 CFM. UL recognized. CSA certified.

POWER CORD:

• 15' - Rated 13A, heavy duty service. Includes a molded 3 prong plug. UL and CSA recognized.

UNIT DRAW:

• Approximately 2.2A at 120V.

BTU OUTPUT:

• 860 BTU

COST TO OPERATE:

• 2/Hr. (Based on Average Electricity Cost of 8/KWH)

TEST OPERATION OF UNIT:


To "test" the unit when ambient air temperature is above 45^oF you must simulate an ambient below 45F. To create the simulation: With the heater unit plugged into a 120V power source, locate the 1/2" dia. hole marked "Test" on the end cover of the unit. Using the 6 oz. can of Freeze Mist spray supplied with your heater, insert the "straw" into the nozzle and spray a 2-3 second burst of mist into the "Test" hole. This will "trick" the thermostat into turning the heater "ON". After a period of time (30 sec. - 3 min.), the ambient temperature of your test environment will resume control of the thermostat and turn your heater "OFF".

BoatSafe's 1000w features reduced footprint ONLY 13.5" L x 5.65" W x 8.5" H and 1000w output. BoatSafe's newest top of the line marine engine compartment heater provides forced-air heat through a patented case design to keep your engine compartment safely above freezing. The Boatsafe boat heater does this while maintaining ignition protection. When the boat heater's sensor detects an ambient temperature of approximately 45 degrees Fahrenheit, it turns on and remains on until the engine compartment reaches approximately 55 degrees Fahrenheit.

BoatSafe Advantages:

• Extend your boating season
  
• Delay Boat Winterization
  
• Economical to use
  
• Keeps engine(s) and wiring dry and corrosion free
  
• Improve battery performance
  
• Enhances the resale value of your boat
  
• Save money by eliminating the annual costs of winterizing & de-winterizing your boat engine(s) in some climates
  
• All BoatSafe bilge heaters meet U.S. Coast Guard Ignition Protection Standards
  
• Extensively tested for your safety and benefit
  
• Endorsed by thousands of boaters like yourself
  
• Full 2-Year Warranty plus a lifetime service guarantee on all BoatSafe boat bilge heaters

More Heat - Less Space:13.5" L x 5.65" W x 8.5" H - 1000 Watt Output - 20 foot prewired power cord - Push-to-Test Feature - Ignition Protected